| |
GPS-PS2GPS Receiver Board
SiRFstar™ II Positioning Engine
| |
|
Overview
The GPS-PS2 receiver is a fully self-contained and shielded GPS receiver board for the Global Positioning System (GPS) based on the SiRFstar™ II technology. The GPS-PS2 receiver board supports a very broad range of GPS enabled products. In automotive applications, the GPS-PS2 supports advanced tracking capabilities through fast recovery times combined with reliable operation in urban canyons and areas of dense foliage.
The GPS-PS2 provides complete GPS signal processing from antenna input to serial data output (NMEA or binary format). It is compatible to the GPS-PS1E.
The GPS-PS2 operates at a nominal voltage of 5 Volts. Advanced power-saving modes allow an additional reduction of power consumption for applications where power consumption is of primary concern. The GPS-PS2 featuring the GRF2i RF front-end chip and an integrated Low-Noise Amplifier (LNA) connects seamlessly to low-cost passive antennas as well as active antennas.
The GPS-PS2 provides two serial ports which can handle NMEA or SiRF® proprietary data format or accept differential GPS data (RTCM). The integrated data logging function stores up to 100'000 logs on the internal FLASH memory.
Further Information:
Product Summary,
Data Sheet
Benefits
- Fully self-contained GPS receiver (PVT output)
- Low power consumption
- Excellent GPS performance
- Supports Satellite Based Augmentation Systems (SBAS)
- Integrated data logging
- Fully EMI shielded
- Passive and active antenna support
- Active antenna supervisor for short and open circuit detection
- Immune to RF interference
Features
- 12 channel GPS receiver
- 1Hz position update rate
- SiRFstar™ II architecture
- GRF2i RF front-end IC
- GSP2e GPS DSP with integrated Real Time Clock
- 8 MBit FLASH memory
- Low-noise amplifier
- Power management features
- TricklePower™ mode
- Push-to-Fix™ mode
- Operating voltage 4.75...5.25 V
- Battery supply pin for internal backup memory and real time clock
- Industrial operating temperature range -40...85°C
- Small size:
- Size: 32mm x 82.5mm
- Height: 7 mm (GPS-PS2 with SSMT) or 12 mm (GPS-PS2-S with SMB)
- Weight: 13g
Ordering Information
|
| GPS-PS2 Receiver Board with SSMT connector | PS2-ST-0-000-0ST-0-000-1 |
| GPS-PS2-S Receiver Board with SMB connector | PS2-ST-1-000-0 |
|
| |
Home 
About us 
u-blox 5 Products
